Loading The Dishwasher - SCHOLTES LVTI 12-55 Instructions Pour L'installation Et L'emploi

Loading the Dishwasher

Load examples
Before placing the dishes in the dishwasher, remove the
Top Rack
Bottom Rack
larger food particles to prevent the filter from becoming
clogged, which results in reduced performance.
If the pots and pans have baked-on food that is extremely
hard to remove, we recommend that they be allowed to
soak before they are washed. This will eliminate the need
for extra wash cycles.
Pull out the racks to facilitate loading the dishwasher.
How to Use the Lower Rack
We recommend that you place the most difficult to clean
items on the bottom rack: pots, pans, lids, serving dishes
and bowls, as shown in the figure to the right.
It is preferable to place serving dishes and lids on the
sides of the racks in order to avoid blocking the rotation
of the top spray arm.
- Pots, serving bowls, etc. must always be placed top
down.
- Deep pots should be slanted to allow the water to flow
out.
- The cutlery basket can be split up by pulling out the
handle.
When you only have little
cutlery to wash, you can use
just half the basket; save space
for other crockery or place the
other half of the basket in the
upper rack instead (see figures
A and B).
This basket is equipped with
two removable grids: insert the
cutlery one by one into the
slots, with the handles at the bottom. knives and utensils
with sharp blades or tips should be positioned with the
sharp parts at the bottom.
Position them so that they don't touch.
How to Use the Upper Rack
Place delicate and lightweight dishes in the upper rack:
glasses, tea cups and coffee cups, saucers - but plates too
- shallow salad bowls, slightly dirty frying pans and shallow
pans.
Position light weight dishes in such a way as to avoid
their being moved by the spray of water.
The appliance can also be equipped with one or two tip-
up compartments onto which you can place mugs and
fig. C
cups, as well as long sharp knives and serving cutlery.
After loading the dishes, remember to check that the blades
on the sprayer arms can turn freely without hitting against
any dishes.
How to adjust the Upper rack
The top rack can be adjusted using the two rack heights
(top and bottom), see fig. C.
EN
15