Start-Up And Use; Starting The Dishwasher - SCHOLTES LVX 12 - 56 Mode D'emploi

Start-up and use

Starting the dishwasher

EN
1. Turn the water tap on.
2. Open the door and load the racks (see Loading the Racks).
3. Measure out the detergent (see adjacent figure) and close
the door.
4. Press the ON/OFF button; you will hear a short beep and all
the indicator lights on the control panel and the display will light
up for a few seconds.
5. Turn the wash cycle selector until the reference notch on the
knob corresponds with the symbol or number of the cycle you
wish to set (consult the wash cycle table contained in this manual,
especially when first using the appliance).
6. Select the wash options (see Wash options
After a few seconds, a beep indicates the wash cycle has started
and the cycle phase in progress indicator light displays the
symbol corresponding to the phase with which it has begun.
Pre-wash, Wash, Rinse and Drying.
The multifunction numeric indicator will indicate the estimated
amount of time left until the end of the wash cycle.
Do not expect a precise countdown as the wash cycle starts
with an estimated cycle time that is updated as the cycle
progresses and according to a number of parameters that affect
the cycle itself (such as water hardness, the temperature of the
water, the degree of soil, etc.).
7. At the end of the wash cycle, 2 beeps are sounded and the
word END flashes. Bring the selector back to the RESET
position, and the 3 dashes for programming cancellation will
appear.
8. Wait for a few minutes before opening the door, in order to
avoid burns. Press the ON/OFF button, unplug the appliance
and shut off the water tap.
9. Wait for a few minutes before removing the crockery, in order
to avoid burns. Unload the racks, beginning with the lower level.
If a mistake was made during the wash cycle selection
process it is possible to change the cycle, provided that it has
only just begun:
To modify it, turn the knob and set it to RESET. After a few
seconds, you will hear 4 beeps, wash cycle indicator relating
to the phase under way will turn off and 3 dashes will appear.
At this point, all the settings will have been cancelled.
To select a new wash cycle, repeat the instructions contained
in the paragraph entitled "Starting the dishwasher".
If the door is opened during the wash cycle, or if there is a
power cut, the cycle stops. It starts again from the point at
which it was interrupted once the door has been shut or once
the electricity supply is restored.
18
Measuring out the detergent

*
)
Compartment A:
Compartment B:
D
*
Only available in selected models.
A
B
cycles
C
Table of wash