SCHOLTES LVX 12 - 56 Mode D'emploi page 19

Wash options*
If you only have a few dishes to wash, you can load these onto
one rack only, saving on both water and electricity. Press button
HALF LOAD, a beep will sound and the symbol corresponding
to the HALF LOAD appears on the display. Each time you
press the button, a beep will sound and symbol corresponding
to the upper rack or symbol corresponding to the lower rack
will appear. If you press the button once more, the selection will
be reset and the dishwasher will consequently wash on both
racks. To use the racks correctly, we recommend you read the
chapter entitled "Loading the racks".
Remember to load the selected rack only, and to reduce
the amount of detergent accordingly.
It is better to use powder detergent in this case.
If you want your dishes to be perfectly dry, follow the
instructions below.
Set the knob to RESET and make any specific settings, such
as:
- upper or lower rack
- delayed start
Start the wash cycle by turning the knob and open the
appliance door. Observe symbol for drying: it will flash for
about 4 seconds, while the word "OFF" appears on the display
(extra drying disabled).
If you press button HALF LOAD immediately, you will hear a
prolonged beep and the word "ON" will appear on the display:
the extra drying has been enabled.
Once you have made your selection, shut the appliance door;
a beep will sound and the wash cycle will either start
immediately or after the delay, wherever set.
Remember that with extra drying, the wash cycle will last
longer, to provide you with drier dishes.
Press button Delayed Start and you can delay the start of the
wash cycle by 24 to 1 hour. Press the button once, a beep will
*
sound and the wording 24 h will come up on the display. Then,
each time you press the button a beep will sound and the hours
will decrease by one hour until the delay is 01 h. If you press the
button once again, the delayed start is reset and 3 dashes appear
on the display.
Note: the delayed start is also reset automatically should
you fail to select the wash cycle on knob wash cycle selector
within 15 seconds.
Once you have set the delayed start time, select the wash cycle
on the knob: after the beep sounds, you will see Delayed Start
indicator light flash on the display and the countdown begins
(indicated on the display one hour at a time). A quick look at the
indicator lights will keep you informed of the countdown progress
at all times.
During the countdown, you can modify the delay by
pressing button DELAYED START repeatedly without
resetting the wash cycle.
If you have changed your mind and wish to start the
wash cycle immediately, press button Delayed Start until
the countdown is fully reset. Indicator light Delayed Start
will turn off and the cycle will start at the sound of a
beep.
The indicator light corresponding to the cycle phase under
way will come up on the display and the countdown to the
estimated cycle end begins.
*
Only available in selected models.
EN
19