Weelko F331 Mode D'emploi page 15

HOT & COLD HAMMER
1. Press "STATE" to select between cold or hot
function.
2. According to the needs, adjust the output
temperature by pressing "ENERGY" and desired time
of operation by pressing "TIMER".
3. Press "START/PAUSE" to start working.
Notes
•
For first time usage, function will start 5 minutes
after all set up.
•
After the first treatment, it needs 3 minutes before
the next Cold or Hot treatment.
•
Best working temperature condition is 25C.
•
Do not block the air tank while using this function, if
not steaming water will be blocked inside the Cold &
Hot hammer, and may induce short circuit.
•
Even after the "START/PAUSE" button has been
turned on to "START", but need to check if the hammer
has been switched to "o", if still in "-", hammer would
not start working.
FAQ
Vacuum – spray
If the suction effect is reduced:
•
Replace the metal and foam filters.