Front Panel; Instructions Of Use - Weelko F331 Mode D'emploi

Front panel

F-331
4 in 1 beauty
instrument

Instructions of use

1. Connect the power supply via the rear panel.
2. Connect the accessories properly to the front/rear
panel as indicated in the sketch.
3. Turn on the "POWER" button.
4. Press "FUNCTION" to select the desired function in
the following order: high frequency, vacuum & spray,
rotary brush, cold & hot hammer.
function
State
Start/Pause
HIGH FREQUENCY
1. Select the proper glass electrode pipe and insert
the metal cap end into the output mouthpiece of the
handle (try not to touch the glass electrode with your
hands or any metal objects).
Glass electrode pipe assignment position:
a. Mushroom-shaped electrode pipe used for large
areas of skin: face, forehead, neck, etc.
b. Ladle-shaped electrode pipe used for medium
areas of skin: chin, etc.
c. Ball-like electrode pipe used for small areas of
skin: nose, etc.
d. Straight electrode pipe used for indirect
treatment.
2. Press " START/PAUSE" button to start working
3. Touch the treatment area with the glass electrode.
You can then slowly adjust the output using
"ENERGY".
4. During the course of the treatment, when changing
electrodes you should return the output to the
minimum level before swapping the electrodes, and
then slowly adjust the energy level and return in to the
appropriate intensity required.
5. At the end of the treatment, slowly reduce the
"ENERGY" level to the minimum output and then
switch the "START/PAUSE" button off before removing
the electrode from the customer's face.
Energy Timer