Climadiff Avintage CVP 186 Notice D'utilisation page 43

"WINTER KIT" LOW TEMPERATURE PROTECTION:
The security of a constant ideal temperature inside your Climadiff wine cellar.
Will an ambient temperature drop have an impact on the preservation quality of my wine cellar?
No ! The temperature inside your wine cellar is automatically regulated with respect to the ambient
temperature of the area where it is located thanks to a totally automatic system.
To avoid subjecting your wines to too abrupt temperature changes when the outdoor temperature suddenly
drops (but not below 0°C and without freezing), Climadiff has developed an automatic WINTER system.
TECHNICALLY SPEAKING, HOW DOES THE WINTER SYSTEM WORK ?
This system is an entirely autonomous system and does not require you to make any intervention. The
system becomes active according to your temperature setting and the ambient temperature.
As soon as the temperature in the bottom of your wine cabinet drops below a temperature of 8°C the winter
system starts running after a short while. The heating resistance warms the entire cabinet very slowly,
smoothly and silently. So, your wines remain under optimum preservation conditions!
IMPORTANT: only the compressor and therefore the refrigeration system generates noise. Heating
is done silently by a heating resistance.
If your wine cellar is in any of these possible cases and does not make any noise, don't worry - this
is not a failure!
The winter system is already preset at 8°C, and we recommend not changing the factory setting. If
nevertheless you want to modify it, you can adjust it between 4°C and 8°C and you can proceed in the
following way.
• Press the SET key "
" during 3 seconds to enter into the menu function.
• The possible settings are: temperature setting, winter system temperature setting, high temperature
alarm setting.
• The different possible settings will be automatically displayed after some seconds in a sequential mode,
or you can select one by pressing successively the SET key " » until the selected one.
• According to your model the below screen is displayed :
• Press the UP and DOWN keys «
» to select the temperature requested, and press the SET key
" » to validate your choice, or wait a few secondes and you will be back into the main menu. When the
setting is selected, the temperature is in a blinking mode, then you can adjust it.
43