Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Superkeys
The BTEL-3G has two SUPERKEYS (the
perform specific actions:
— When you press
, a call is made to the telephone number stored at position 9 in the phone book and the
speakerphone function is enabled. After 5 minutes and after that at 30-second intervals, a tone is sounded on the audio
channel. To end the call, press or wait for the other party to hang up.
— When you press
, a call is made to the telephone number stored at position 9 in the phone book and voice message
no. 7 is played five times. If the call result is not successful (no answer, busy, or unreachable), the device automatically
attempts to call again 5 times (after 1, 2, 5, and 10 minutes). Repeated call attempts can be ended by the Block Calls option
(see the "Block Calls" section) or by activating Input no. 4 (L4).
The SUPERKEY
During calls made with Superkeys
Remote Programming by text message
By sending specific text messages, you can manage some features of the BTEL-3G. For the features, see the paragraphs
below.
Output Management
Open Collector outputs OC1, OC2, and OC3 can be set as Bistable (enabled and disabled with 2 different commands) or as
Monostable (the output is active for its ON Time, after which it returns to standby). Output OC4 is set as Bistable.
If the output is enabled by sending a text message, Confirm Output Activation Enable (if programmed by
the installer) will be sent by text message.
Bistable Output
Open Collector outputs set as Bistable can be enabled or disabled by sending a text message with the following format
(use capital letters):
where the following are enclosed by # signs : User PIN is a numeric code of 5 digits (from 00000 to 99999); Output is the Open
Collector Output (OC1, OC2, and OC3); ON enables the output; OFF disables the output.
The factory default User PIN is "00000". To change it, see the Section "User->Change Code".
Monostable Output
The Open Collector Outputs set as Monostable can be enabled by sending a text message with the following format (use capital
letters):
where the following are enclosed by # signs : User PIN is a numeric code of 5 digits (from 00000 to 99999); Output
is the Open Collector Output (OC1, OC2, and OC3); ON enables the output.
OC Outputs set as Monostable return to standby status after their programmed ON Time.
The factory default User PIN is "00000". To change it, see the Section "User->Change Code".
12
key and the
function cannot be enabled if other calls are in progress.
and
the other party can access the User Menu remotely by pressing
#User PIN#Output#ON# (example: #85649#OC1#ON#)
#User PIN#Output#OFF# (example: #85649#OC1#OFF#)
#User PIN#Output#ON# (example: #85649#OC1#ON#)
key), which, when pressed for at least 3 seconds,
.
BTEL-3G
Publicité
Chapitres
Table des Matières
