Switching On And Off - Iqua BHS-801 Mode D'emploi

BHS-801_Headset_UG_en_2.fm Page 4 Monday, September 25, 2006 2:20 PM

Switching on and off

To switch the headset on, press and hold down the
green light flashes several times.
To switch the headset off, press and hold down the
red light flashes several times.
Pairing the headset and your mobile phone
Using the headset for the first time
When the headset is powered on for the very first time, it will automatically enter pairing mode.
This is indicated by red and green lights flashing alternately. Follow the steps 2 to 4 below to
pair your mobile phone with the headset.
Using the headset later on
When the headset is powered on, it will automatically reconnect to the phone it was last
connected with. If the connection fails because the phone is not found, the headset will appear
not connected with green light flashing and you should finish pairing manually:
1. After the power has been switched on, press and hold down the Call button until the red
and green lights start flashing alternately.
2. Complete the pairing with your phone. Please refer to the manual of your phone for
details on how to search and pair. When the phone has found the headset, the phone will
show Iqua BHS-801 on its display.
button until you hear a beep and a
button until you hear a beep and a
4