Falltech DuraTech 6 Mini Single Manuel De L'utilisateur page 12

Ensure the carabiner is correctly installed on the FBH as shown in Figure 10. Incorrect installation may result in serious injury or death.
A
B
C
D
E
5.8.4 Twin-leg SRD Work Zone Transition: This SRD is designed for attachment of one leg end at a time during work performance. Dual
connection is for transitioning from one work zone to another only. See Figure 12.
Attach one leg end connector to a suitable anchor. The user may then move to another work location and attach the unused leg to
another suitable anchorage. Detach the original attached leg. Repeat the procedure, until the desired work location is reached.
A
B
C
D
E
CMSRD07 Rev A
Figure 11 shows common incorrect connections.
Figure 11 - Incorrect Twin-Leg SRD Attachment
DO NOT Attach directly to the Dorsal D-ring
DO NOT Attach to only one of the intersecting web straps
DO NOT Attach to intersecting web straps over/above the Dorsal D-ring
DO NOT Attach anywhere outside the intersecting web straps
CORRECT Attachment to both intersecting web straps with Dorsal D-ring in the up position
Figure 12 - Use of Twin-Leg SRD for Lateral Movement
Original Work Location before lateral movement
Starting lateral movement; one leg connected to Anchor
During lateral move; both legs connected in momentary transition between Anchors
Ending lateral movement; one leg connected to Anchor
New Work Location after lateral movement
WARNING
040220 12