Fantech SHR6904 Manuel D'installation page 8

8
Installing BYPASS Module (BPM) - SHR6905R/SHR11005R
Kit content
• 1x BPM assembly
• 1x bracket "A"
• 2x bracket "B"
• 10x Screws
• 1x black extension wire*
• 1x red extentson wire*
* Only used when electrical box is
reversed
Figure 1 Figure 2
Bracket "B" Installed Bracket "A Installed
1. Loosely fasten both 2. Using the same screw
brackets "B" to cabinet
using screws in the pilot
holes (Fig. 1). Don't drive
the screw all the way;
leave about ¼" of thread
for the step 4.
Figure 6
Insert damper motor wires
through bushing
5. Next route the damper motor wires through the plastic bushing (Fig.6) of
the electrical box and run the wires to the HCE controller on the terminal
marked "N.O." in the field marked "DAMPER" and on the terminal marked "C"
in the field marked "24VAC". (Fig. 7)
Figure 3
BPM Tilted
3. Install BPM by tilting it
already on the unit,
assemble bracket "A" on
the cabinet (Fig. 2).
Figure 7
HCE Controller, showing "N.O."
terminal location and "C" terminal
location
Bracket "B"
Figure 4
BPM Fastening
4. Assemble the remaining fasteners to secure the BPM
(Fig. 3) so that the hole (Fig. 4). Continue to tighten the fasteners holding the
on the mounting bracket bracket "B" to cabinet in order to compress the gasket
"A" lines up with the between the BPM and the cabinet (Fig. 5).
pilot hole on top of the
BPM. Secure it with the
fastener and release
the BPM. The tilting
will enable the hole to
line up properly and will
compress the gasket
once released.
Bracket "A"
Figure 5
Bracket "B" tightened