3. Operation
3.4.1
Remote Exposure Switch and Power Cable Connections
There are four connectors on the bottom of the Power Box Assembly as described
below.
Connector 1, 2, 3: Remote Exposure Switch Connectors
⚫
Connector 4: AC Power Cable Connector
⚫
The standard and optional Remote Exposure Switches, and the Door Interlock
Cable are connected to the Connector 1, 2, and 3. Please check all seven possible
options in the table below.
32
1 2 3 4
Before connecting the cables, ensure that the DIP switch setting is
set according to the instructions in the following table.
Refer to the location of the DIP switch in the following figure.
DIP Switch
EzRay Air Wall (VEX-S300W) User Manual