Maintenance - Fantech SHR 8005R Mode D'emploi

Maintenance

CAUTION
MAKE SURE UNIT IS UNPLUGGED BEFORE ATTEMPTING ANY MAINTENANCE WORK
The following components should also be inspected regularly and well maintained.
The motor - The motors are
factory balanced and lubricated
for life. They require no
maintenance.
The unit - The inside of the unit
should be wiped clean as
needed.
Condensation Pan - Units with
drain hoses should have their
line and connection checked
regularly.
Outside hoods - The outside
hoods need to be checked every
season to make sure there are
no leaves or insects blocking the
airflow. Check regularly that
there are no pollutants near the
intake hood. Make sure they are
clear of any snow accumulation
during the winter months.
FILTERS
The filters need to be checked and cleaned once a month or when they appear dirty.
FIXED PLATE
Clean cores on a average every 3-6 months or as needed.
a) Open access door & remove filters.
b) Carefully pull on handle of core and pull evenly outward. Cores
may be snug, but will slide out of the channel.
c) Wash the cores in warm soapy water or light coil solution.
d) Install clean cores making sure the matting surfaces have
one sealing edges between each cores to minimize leaks.
e) Install the clean filters
f) Replace access door
Note: Core installation label on the outer end of the core.
To install the clean Core and Filters.
a) First mount the bottom flange of the core guide into the
bottom channel approximately 6mm (1/4")
b) Mount the left or right side flange of the core guide
approximately 6mm (1/4") followed by the other side
c) Mount the top flange of the core guide into the top
channel approximately 6mm (1/4")
d) With all four corners in place and the core straight and even,
push hard in the centre of the core until the core stops on
the back of the cabinet.
13
fantech