Safety; Electrical Safety - FujiFilm PowerPark Guide D'utilisation

2 Clean the stand module and PowerPark dock surfaces to remove any debris or bodily fluids. Use the
following procedure:
a Use either a pre-moistened wipe or a soft cloth dampened with cleaner or disinfectant.
b Remove all gel, debris, and bodily fluids from the PowerPark components.
3 With a new wipe, clean all parts of the PowerPark components by wiping from the clean areas to the
soiled areas. This method helps to avoid cross-contamination.
Follow the chemical manufacturer's instructions regarding temperature and wet contact time. Monitor the
PowerPark parts for wet appearance, and reapply with a new wipe if no longer wet.
4 Allow the PowerPark components to air dry in a clean, well-ventilated space.

Safety

For maximum safety, observe all of the warnings and cautions in this section.

Electrical safety

Table 2: Electrical safety classification
Class I equipment The PowerPark is classified as Class I equipment.
Non AP/APG The PowerPark is not suitable for use in the presence of flammable anesthetics.
Safety Safety 7 7