Lincoln Impinger 3200 Serie Manuel D'entretien & Manuel D'installation page 27

Section 4
15. Install top and bottom fingers in the oven by sliding
them over the plenum flange and setting on the front
bracket. BE SURE THAT THE FINGER SETS SQUARELY
OVER THE PLENUM FLANGES AND THE HOLES POINT IN
THE PROPER DIRECTION. Top fingers point down. Install
in the same position they were removed from.
16. Install the door.
17. Reinstall the conveyor. Ensure front door is in place
prior to installing the conveyor. Trying to install the
conveyor without the door in place is very difficult and
may cause damage to the unit. Insert the conveyor
through the opening in the right side. Sprocket will be
to the right side of the conveyor.
Conveyor Replacement
Part Number 11020000487 Rev A (2/16)
18. Slide conveyor through the oven chamber until
19. Lift conveyor just enough to allow you to pull the
20. Inspect sprocket alignment and adjust if necessary.
21. Reinstall conveyor crumb pans and chain guard cover.
22. Reapply power.
23. Clean any dirt from the louvers, on the control box
Conveyor
Drive Chain
Drive
1/2" Sag
Sprocket
Drive Motor
Sprocket
the locking bar on the drive end of the conveyor is
approximately 2" – 3" (50 – 76 mm) into the oven
chamber. Install drive chain by placing it over the drive
sprocket and placing it over the conveyor sprocket.
conveyor toward you until the locking bar is outside of
the oven cavity. At the same time, push the conveyor
downward so that the bar locks on the outside of the
oven wall.
cooling fan, and openings on the rear wall (cover).
Maintenance
27