Table des Matières
Publicité
SECTION 7 − OPERATING AUXILIARY EQUIPMENT
.
The welding generator provides power while welding and with the Amperage control in any position. However, under these conditions equipment
connected to the welding generator may be subject to larger than normal voltage fluctuations. It is recommended that only lamps be powered under
these conditions.
7-1. Generator Power Panel Receptacles
.
Generator power decreases as weld
current increases.
Set Weld Output control to maximum
for full generator power output at AC
receptacles.
1
120 V 20 A AC GFCI Receptacles
GFCI−2 and GFCI−3
GFCI−2 and GFCI−3 supply 60 Hz single-
phase power at weld/power speed. Maxi-
mum output from GFCI−2 or GFCI−3 is 2.4
kVA/kW.
If a ground fault is detected, the GFCI Re-
set button pops out and the circuit opens
to disconnect the faulty equipment. Check
for damaged tools, cords, plugs, etc. con-
.
Complete Parts List available at www.HobartWelders.com
nected to the receptacle. Press button to
reset receptacle and resume operation.
.
At least once a month, run engine at
weld/power speed and press Test but-
ton to verify GFCI is working properly.
NOTICE − Do not parallel the two 120 V
duplex receptacles.
2
240 V 50 A AC Receptacle RC1
RC1 supplies 60 Hz single-phase power at
weld/power speed. Maximum output is 4
kVA/kW.
3
Supplementary Protector CB1
CB1 protects the receptacles from over-
load. If CB1 opens, the receptacles do not
2
3
work. Place switch in the on position to re-
set.
.
Place switch in the On position to re-
set. If supplementary protector contin-
ues
Authorized Service Agent.
Combined output of all receptacles limited
to 4 kVA/kW rating of the generator (See
Section 12 − Generator Power Guide-
lines).
EXAMPLE: If 15 A is drawn from the 120
volt duplex receptacle, only 9 A is available
from the 240 V receptacle.
(120 V x 15 A) + (240 V x 9 A) = 4 kVA/KW.
1
250 186-A
to
open,
contact
Factory
OM-250 200 Page 29
Publicité
Table des Matières
