Control Of Grill Burner - LG LGG6060 Manuel Du Propriétaire

4. USE OF YOUR PRODUCT

4.1.3 Control of grill burner

!
CAUTION: Accessible parts may be hot when the grill is in use. Young children should be kept
away.
Right after you ignite the burner, place the grill heat shield under the control panel. After that, lift
the oven door up slowly until it stops at the semi-open (30 °) position and touches the heat shield.
Assembling the grill heat shield
Hold the heat shield as the warnings face upwards. There are two small slots on the right and left
side of the rear edge of the shield, as shown in the below figure.
There are two screw equipped with bushes under the oven control panel. Align the bushes with the
assembly slots so that the shield is stuck between the control panel and the bush. Push the shield
towards the appliance until it is firmly in its place.
Cooking
• The grill burner cannot be modulated between maximum and minimum positions and creates a
source of heat at a constant rating. When turning the grill burner off, turn the knob in the
clockwise direction so that the knob shows "0" position.
• Place the tray on the shelf below the grid in order to collect the fat during grilling.
• Place the wire grid on the topmost shelves; 5 or 6 ; provided that the food does not touch the
grill burner.
• Preheat the grill on a full setting for a few minutes before sealing steaks or toasting. The food
should be turned over during cooking as required.
th th
20
Figure 20