Samsung WW10H9 Serie Manuel D'utilisation page 17

For models with an additional hot water inlet:
1. Connect the red end of the hot water supply hose to the hot
water inlet on the back of the machine.
2. Connect the other end of the hot water supply hose to the
hot water tap.
Aqua hose (applicable models only)
The aqua hose alerts users of a risk of water leaks. It senses the
water flow and turns red on the centre indicator (A) in case of a
leak.
STEP 5 - Position the drain hose
The drain hose can be positioned in three ways:
Over the edge of a wash basin
The drain hose must be placed at a height of between 60 cm and
90 cm (*) from the floor. To keep the spout of the drain hose bent,
use the supplied plastic hose guide (A). Secure the guide to the
wall using a hook to ensure stable drainage.
ln a sink drain pipe
The drain pipe must be above the sink siphon so that the end of the hose is at least 60 cm above
the floor.
ln a drain pipe
The drain pipe should be between 60 cm and 90 cm high (*). It is
advisable to use a 65 cm high vertical pipe. Make sure the drain
hose is connected to the stand pipe at a slant.
Drain standpipe requirements:
• Minimum diameter of 5 cm
• Minimum carry-away capacity of 60 litres per minute
STEP 6 - Turn on the washing machine
Plug the power cord into a wall socket featuring an AC 220-240 V / 50 Hz approved electrical
outlet protected by a fuse or circuit breaker. Then, press the Power button to turn on the washing
machine.
Untitled-42 17
English - 17
A
A
2016-02-20 3:33:38