Samsung WW10H9 Serie Manuel D'utilisation page 16

6. While holding down part (E), connect the water supply hose
to the adaptor. Then, release part (E). The hose fits into the
adaptor with a clicking sound.
7. Connect the other end of the water supply hose to the inlet
valve on the back of the washing machine. Turn the hose
clockwise to tighten.
8. Open the water tap and check if there are any leaks around
the connection areas. If there are water leaks, repeat the
steps above.
• If using a screw type of water tap, connect the water hose to
the water tap as shown.
WARNING
Stop using the washing machine if there is a water leak, and contact a local Samsung
service centre. Otherwise, this may cause electric shock.
CAUTION
Do not stretch the water supply hose by force. If the hose is too short, replace the hose with
a longer, high-pressure hose.
• After connecting the water supply hose to the adaptor, check if it is connected properly
by pulling the water supply hose downwards.
• Use a popular type of water taps. If the tap is square-shaped or too big, remove the
spacer ring before inserting the tap into the adaptor.
Untitled-42 16
English - 16
E
2016-02-20 3:33:38