Unold NEBULA Notice D'utilisation page 25

1. Before assembling, ensure that you are assembling the appliance in a place
that is level and dry.
2. Remove all packaging materials and transport safeguards. Keep the packag-
ing material, such as plastic bags or Styrofoam away from small children
- danger of suffocation!
3. Check whether all needed parts are present.
4. Turn the base upside down so that you are looking at the underside of the
base. Screw the five provided rollers into the associated five holes. Then
turn the base right-side-up.
5. There is a threaded ring on the underside of the housing. Unscrew this
threaded ring from the housing. Insert the housing into the aperture of the
base and firmly screw the threaded ring back onto the underside of the base.
6. Insert the motor with stand tube into the housing and ensure that both parts
are properly connected. The black locking screw (15) can only be properly
screwed in through the opening in the stand tube if both parts are properly
connected.
7. Remove the nut (6) from the motor housing (8/9) by turning it anti-clock-
wise.
8. Fasten the rear grille on the motor, by fixing the cover in place with the nut
(6) (Fig. 1). In this process do not press too firmly. In this process pay atten-
tion to the apertures/pins.
9. Place the impeller on the axle on the motor housing. Fix the impeller in
place with the fastening ring (4) (turn it anti-clockwise). Check whether
the fan blades move freely. Note: The fastening ring tightens itself, conse-
quently, do not use excessive force when fastening (Fig. 2).
10. Remove the three screws (3) on the rear of the ornamental ring trim (1). Fit
the ornamental ring trim onto the front grille and firmly fasten it with the
three screws.
Fig. 1
25