Led Indicator - activTek INDUCT 2000 Guide D'utilisation

R E P L A C I N G T H E B A L L A S T
A
B
6
6. To reconnect wiring, (A) press each tab on the ballast and insert wire. (B)
Release tab and gently pull wire to ensure it is properly locked into place.
UPPER (6 terminals)
• Black LED wire in LED+
• White LED wire in LED-
• 2 Blue wires in BLUE
• 2 Red wires in RED
7
7. Replace cover and secure with
the original four (4) screws.
( co nt i n u e d )
LED+ LED- RED RED BLUE BLUE
BLACK WHITE GREEN
14
LOWER (3 terminals)
• Black power wire in BLACK
• White power wire in WHITE
• GREEN is not used
8

LED INDICATOR

8. Re-install unit if removed from duct.
Reconnect power and check for
proper operation (LED indicator
should be lit when in operation).
15