Changing The Activepure® Cell - activTek INDUCT 2000 Guide D'utilisation

CHANGING THE ACTIVEPURE® CELL
WARNING! - UV Light in operation. Disconnect unit from power supply
before servicing. Failure to follow warnings may result in severe eye
damage.
1
1. Unplug unit. If the unit is hard wired,
be sure the power to the unit is off.
Always follow OHSA electrical lockout safety
requirements to prevent Accidental release of energy
during service or maintenance activities
3
3. Remove the unit from the mounting plate.
5
5. Separate the used ActivePure® cell from the
base unit and dispose of properly.
7
7. Secure with 2 thumb screws.
9
9. Secure unit with 4 thumb nuts.
2
2. Remove the 4 thumb nuts.
4
4. Remove the 2 thumb screws holding
the ActivePure® Cell.
6
6. Plug the new ActivePure® cell into the
base unit.
8
8. Insert the unit into the mounting plate.
10
10. Reconnect power
supply.
13