BH FITNESS LK500Ri Guide D'utilisation page 19

STEP 6
Slide the Control Tube Decorative Cover (O) onto Control Tube (F)- see Figure 6-1. Then
thread the lower control wires from the Front Frame (A) through the Control Tube (F). Then
attach the Control Tube (F) and Front Frame (A) with the Truss Hex Screws (K13), Spring
Washers (K14) and Flat Washers (K21), tighten firmly. Attach the Handrail Tube (E) to the
Control Tube (F) with Truss Hex Screws (K16), Spring Washers (K14) and Flat Washers (K15).
Connect all wires from the Console (G) with the wires you threaded through the control tube.
Tuck the connected wires into the Control Tube (F). Then attach the Console (G) to the Control
Tube (F) with Truss Phillips Screw (K17). Then assemble the left & right pedals (L, K). Each
pedal is labeled with an "L" and "R" for left and right, please make sure that you are attaching
the correct pedal onto the correct side.
19