Operation And Maintenance; Up And Down Buttons; Stop Function; Favourite Position (My) - SOMFY S&SO-RS100 io Notice

3. OPERATION AND MAINTENANCE

This drive does not require any maintenance operation.
If no io-homecontrol
automation professional.

3.1. UP AND DOWN BUTTONS

A brief press on
move all the way up or all the way down.

3.2. STOP FUNCTION

The roller shutter is moving.
press the
-
stops automatically.

3.3. FAVOURITE POSITION (my)

An intermediate position called "favourite position (my)" other than the fully up or fully
down position is programmed by default in the S&SO-RS100 io.
Perform 2 complete
-
shutter to activate the favourite position.
To modify or delete the favourite position (my), see section Additional settings.
To use the favourite position (my):
my
press
-
stops in the favourite position (my).
3.4. OPERATION WITH A Somfy io-homecontrol
SUNIS WireFree™ io)
Refer to the corresponding guide.

3.5. FEEDBACK

The S&SO-RS100 io sends a message after each order. This information is processed by
the io-homecontrol
®

3.6. ADDITIONAL SETTINGS

Set the roller shutter to the desired favourite
1)
position (my).
my,
Press
2)
forth movement by the roller shutter: the desired
favourite position (my) is now programmed.
3.6.2. Deleting the favourite position (my)
my
Press : the roller shutter moves and stops at
1)
the favourite position (my).
my
Press again until the roller shutter moves: the
2)
favourite position (my) is deleted.
3.6.3. Adding/Deleting Somfy io-homecontrol
Refer to the corresponding guide.
Copyright © 2014 - 2016 Somfy SAS. All rights reserved.
control point is programmed: contact a home motorisation and
®
V
or causes the roller shutter to
my
button: the roller shutter
V
or cycles as far as the upper and lower end limits of the roller
: the roller shutter moves and
two-way control points.
5 s, until there is back and
my
SUN SENSOR (SUCH AS
®
1)
my
1)
my
control points and sensors
®
Non contractual images.
EN
my
2)
my
2)
my
29