Prior Information; Fields Of Application; Liability - SOMFY S&SO-RS100 io Notice

EN
The S&SO-RS100 io drive is a new generation drive designed to offer improved
convenience and safety for users and greater simplicity for installers when setting up due
to optimal adaptability of the drive to roller shutters (default Plug&Play drive, for which
settings may be adapted depending on the equipment level of the roller shutter).
This drive offers innovative functions thanks to the new SMS technology (Smart
Motion System) accessible via the io-homecontrol
These functions are also accessible via the Smoove RS100 io control point developed
exclusively for drives using SMS technology.

1. PRIOR INFORMATION

1.1. FIELDS OF APPLICATION

The S&SO-RS100 drive is designed to motorise all types of roller shutters complying with
at least one of the following conditions:
- The roller shutter apron can be lifted by 4 cm when an upward force of 150 N is applied
to the end slat positioned at 16 cm from its totally extended position.
- The roller shutter is controlled by a control point without locking, installed within sight of
the closing but away from moving parts and at a height of at least 1.50 m.
- The end closure zone is located at a height in excess of 2.50 m from the ground or any
permanent access level.
If the roller shutter is equiped with openwork slats, a 5 mm diameter rod must not pass
through the openings.

1.2. LIABILITY

Before installing and using the S&SO-RS100 io drive, please read these instructions
carefully. In addition to the instructions provided in this guide, please also comply with the
instructions set out in the enclosed document Safety instructions.
The S&SO-RS100 io drive must be installed by a home motorisation and automation
professional, in accordance with Somfy's instructions and the applicable
regulations in the country of installation.
above is prohibited. Such operation shall exclude Somfy from all liability and invalidate
the Somfy warranty, as will any failure to comply with the instructions given herein and in
the enclosed Safety instructions document.
After installing the S&SO-RS100 io drive, the installer must inform his customers of the
operating and maintenance conditions for the S&SO-RS100 io drive and must pass
the operating and maintenance conditions on to them, as well as the enclosed Safety
instructions document. Any After-Sales Service operation on the S&SO-RS100 io drive
requires intervention by a home motorisation and automation professional.
Should any doubt arise during installation of the S&SO-RS100 io drive or for additional
information, consult a Somfy contact or visit www.somfy.com.
Safety warning!
22
Copyright © 2014 - 2016 Somfy SAS. All rights reserved.
Caution!
V
"Up" button
installation tool Set&Go io.
®
Information
"Down" button
Non contractual images.