Tips And Advice On Operation; Frost Protection; Technical Data - SOMFY S&SO-RS100 io Notice

EN

3.7. TIPS AND ADVICE ON OPERATION

3.7.1. Questions on the S&SO-RS100 io?
Observations
The roller shutter does
not operate.
If the roller shutter still does not work, contact a home motorisation and automation professional.
3.7.2. Detecting obstacles
Automatic obstacle detection makes it possible to protect the roller shutter apron and clear
away obstacles:
If the roller shutter apron comes up against an
-
obstacle when moving down then, depending on the
position of the obstacle:
• Either the roller shutter stops automatically.
• Or it stops and is raised again automatically.
If the roller shutter apron encounters an obstacle
-
when moving upwards, the roller shutter stops
automatically.

3.7.3. Frost protection

Frost protection functions in a similar way to obstacle
detection:
If the S&SO-RS100 io detects resistance, it stops automatically to protect the roller shutter
-
apron:
The roller shutter remains in its initial position.
-
3.7.4. Replacing a lost or broken Somfy io-homecontrol
To replace a lost or broken io-homecontrol
automation professional.

4. TECHNICAL DATA

Radio frequency
Frequency bands and maximum power used
Power supply
Operating temperature
Protection rating
Maximum number of control points
associated sensors
Safety level
Somfy SAS, F-74300 CLUSES as manufacturer hereby declares that the drive covered by these instructions when
marked for input voltage 230V~50Hz and used as intended according to these instructions, is in compliance with the
essential requirements of the applicable European Directives and in particular of the Machinery Directive 2006/42/EC, and
the Radio Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at www.somfy.com/ce.
Antoine Crézé, Approval manager, acting on behalf of Activity director, Cluses, 05/2016.
30
Copyright © 2014 - 2016 Somfy SAS. All rights reserved.
Possible causes
The io-homecontrol control point
®
battery is low.
The drive is in frost protection
.
mode
The overheating protection on the
drive has been activated.
and
Check the battery and replace it as required.
Refer to the guide for the control point.
Wait until the temperature reaches a point
where the roller shutter can move again.
Wait for the drive to cool down.
®
control point, contact a home motorisation or
®
868-870 MHz io-homecontrol® two-way Tri-band
868.000 MHz - 868.600 MHz e.r.p. <25 mW
868.700 MHz - 869.200 MHz e.r.p. <25 mW
869.700 MHz - 870.000 MHz e.r.p. <25 mW
230 V 50 Hz
- 25°C to + 60 °C
IP 44
9
Class II
Solutions
control point
Non contractual images.