Technical Data - LaserLiner LaserRange-Master i3 Mode D'emploi

Information on maintenance and care
Clean all components with a damp cloth and do not use cleaning agents,
scouring agents and solvents. Remove the battery(ies) before storing for
longer periods. Store the device in a clean and dry place.
Calibration
The meter needs to be calibrated and tested on a regular basis to ensure
it produces accurate measurement results. We recommend carrying out
calibration once a year.

Technical Data

Precision (typical)*
Measurement range
(inside)**
Laser class
Laserwellenlänge
Operating conditions
Storage conditions
Automatic switch-off
Power supply
Dimensions (W x H x D)
Weight (incl. batteries)
* measuring distance up to 10 m with strongly reflective target surface
and at room temperature. The measurement deviation may increase
by ± 0.2 mm/m for weakly reflective target surfaces.
** at max. 5000 lux
EU directives and disposal
This device complies with all necessary standards
for the free movement of goods within the EU.
This product is an electric device and must be
collected separately for disposal according to
the European Directive on waste electrical and
electronic equipment.
Further safety and supplementary notices at:
http://laserliner.com/info?an=lrmi3
LaserRange-Master i3
(Subject to technical changes without notice. 18W32)
± 2 mm
0.3 m - 30 m
2 < 1 mW
635 nm
-10°C...40°C, max. humidity 20...85% rH,
no condensation, max. working altitude
2000 m above sea level
-20°C...70°C,
max. humidity 80% rH
30 sec laser / 3 min device
2 x AAA 1.5 volt batteries
40 x 110 x 24 mm
90 g
13
EN