Volume Measurement; Important Notices; Error Codes - LaserLiner LaserRange-Master i3 Mode D'emploi

Volume measurement:

Volume
Min./max. measurement:
Min./max.
measurement
Min. measurement
The LC display shows the lowest value (min.) and the current value.
Max. measurement
The LC display shows the highest value (max.) and the current value.

Important notices

– The laser points to the location that will be measured.
No objects may get into the laser's line of measurement.
– The device compensates the measurement for different room
temperatures. Therefore allow the device a brief adaptation period
when changing locations with large temperature differences.
– The device is only conditionally useable in outdoor areas and cannot
be used in strong sunlight.
– The measurement results of outdoor measurements may be influenced
or falsified by rain, fog and snow.
– In unfavourable conditions, e.g. with poorly reflecting surfaces,
the maximum deviation may be greater than 3 mm.
– Carpeting, upholstery or curtains will not reflect the laser optimally.
Measure to flat surfaces.
– Measurements made through glass (window panes) can falsify
measurement results.
– An energy-saving function switches the device off automatically.
– Clean with a soft cloth. Water may not be allowed to penetrate
the housing.

Error codes:

Err15: Outside the measuring range
Err16: Received signal too weak
Err26: Value outside display range
12
EN
1. measurement 2. measurement 3. measurement
1x 2x
Laser on
1x
3x 4x
Measure
2x
5x 6x
Stop
3x