Commissioning The Appliance; Attaching The Cover; Adjusting The Door Opening Angle; Changing The Door Spring - Thermador T18BF Série Instructions D'installation

15. Commissioning the appliance

m
CAUTION
Check that the finger guard functions. In particular check
– that the finger guard is correctly attached to the
appliance and
– that the finger guard slides smoothly forwards and
backwards when the appliance door open and
close.
To guarantee the accuracy of the following working steps
and thus the appearance of the overall kitchen front later on,
the appliance should now be operated.
Open the appliance door.
Press the POWER button.
Only for appliances with a water connection:
NOTE
In order to avoid the risk of damage caused by leaking
water from damage possibly caused to the water pipe
feeding the appliance, keep the shut-off valve closed.

16. Attaching the cover

Press cover strip on the handle side of the door into the
gap between stainless steel front and appliance door.

17. Adjusting the door opening angle

Depending on the installation situation, it may be necessary
m
to adjust the door opening angle. A door opening angle of
115° has been set at the factory.
To adjust the door opening angle to 90°:
Open the door to 90°.
Insert the banking pin through the boreholes which are
now vertically aligned and drive in with a hammer.

18. Changing the door spring

To adjust the door spring:
Rotate the adjusting screw with a cross-head
screwdriver.
I = maximum spring tension
0 = no spring tension
27