LG LNXS30996 Série Manuel Du Propriétaire page 67

Ice & Water
Problem
Infrequent use of the
dispenser.
The delivery chute is clogged
with frost or ice fragments.
Ice is not
dispensing.
The dispenser display is
locked.
Ice bin is empty.
Water filter has been
exhausted.
Water is dispensing
slowly.
Reverse Osmosis filtration
system is used.
Low house water supply
pressure.
New installation or water line
recently connected.
Water is not
dispensing.
The dispenser panel is locked.
The dispenser is not set for
water dispensing.
Possible Cause
• Infrequent use of the ice dispenser will cause the cubes
• Eliminate the frost or ice fragments by removing the
• Press and hold the Lock button for three seconds to
• It may take up to 24 hours for each compartment to
• Replacing the water filter is recommended:
• Approximately every six months.
• When the water filter indicator turns on.
• When the water dispenser output decreases.
• When the ice cubes are smaller than normal.
• Reverse osmosis filtration systems can reduce the
• The water pressure must be between 20 and 120 psi
• Dispense 2.5 gallons of water (flush for approximately
• Press and hold the Lock button for three seconds to
• The dispenser can be set for ice or water. Make certain
TROUBLESHOOTING
Solutions
to stick together over time, which will prevent them from
properly dispensing. Check the ice bin for ice cubes
clumping/sticking together. If they are, break up the ice
cubes to allow for proper operation.
ice bin and clearing the chute with a plastic utensil.
Dispensing cubed ice can also help prevent frost or ice
fragment buildup.
unlock the control panel and dispenser.
reach the desired temperature and for the icemaker
to begin making ice. Make sure that the shutoff (arm/
sensor) is not obstructed. Once the ice supply in the
bin has been completely exhausted, it may take up
to 90 minutes before additional ice is available, and
approximately 24 hours to completely refill the bin.
water pressure below the minimum amount and result
in icemaker issues. If the problem persists, it may be
necessary to contact a plumber.
on models without a water filter and between 40 and
120 psi on models with a water filter. If the problem
persists, it may be necessary to contact a plumber.
5 minutes) to remove trapped air and contaminants
from the system. Do not dispense the entire 2.5
gallon amount continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
unlock the control panel and dispenser.
that the control panel is set for the proper operation.
Press the Water button on the control panel to
dispense water.
67