Pioneer HTP-076 Mode D'emploi page 74

Setting Item Default Value Setting Details
Surround Small Set the low range capabilities for each channel by
setting either small or large.
"Small": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low
range capabilities
• When "Front" is set to "Small", this is set to
• If an item cannot be selected even though
Crossover 150Hz When there are speakers that have been set to
"Small", set the Hz under which you would like
other speakers to play bass, and also set Hz under
which you would like the LFE (low frequency effect)
to play the bass.
The value from "50Hz" to "200Hz" can be set.
Double Bass On This can be selected only when "Configuration"
- "Subwoofer" is set to "Yes" and "Front" is set to
"Large".
Boost bass output by feeding bass sounds from
the front left and right, and center speakers to the
subwoofer.
"On": Bass output will be boosted
"Off": Bass output will not be boosted
Contents
"Small".
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Connections
≫
„ 3. Distance
Set the distance from each speaker to the listening position.
Setting Item Default Value
Front Left 10.0 ft/3.00 m
Center 10.0 ft/3.00 m
Front Right 10.0 ft/3.00 m
Height Left 10.0 ft/3.00 m
Height Right 10.0 ft/3.00 m
Surround Right 10.0 ft/3.00 m
Surround Left 10.0 ft/3.00 m
Subwoofer 10.0 ft/3.00 m
• Default values vary depending on the regions.
• The unit of distance can be changed by pressing the MODE button on the remote
controller. When using the unit "feet", the setting is available in increments of 0.1 ft from
0.1 ft to 30.0 ft. When using the unit "meter", the setting is available in increments of
0.03 m from 0.03 m to 9.00 m.
74
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
≫