ResMed Swift FX Bella Gray Mode D'emploi page 22

1. Thread each strap through the soft sleeve. Pull the soft sleeve
up until it sits flush against the widest part of the strap.
Ensure the soft sleeve lies flat on the strap.
2. Hold the buckle with the arrow facing up.
A. Ensuring the notches of the strap are facing the arrow
head, thread the end of the strap down through the
opening closest to the arrow head on the buckle.
B. Bring the end of the strap up through the other opening,
making sure that the notches on the strap sit against
each other.
Repeat these steps with each strap.
3. Ensure that the straps are not twisted.
Fitting
The Swift FX fitting illustrations in this user guide show the sequence
for obtaining the best fit and comfort when using your mask.
Fitting steps
1. Hold the pillows at your nose ensuring that the ResMed logo
is on the top of the pillows facing up. Pull the headgear over
your head. The headgear should sit midway between the ears
and eyes.
2. Adjust the top straps by pulling the strap through the buckle,
one notch at a time. Do not overtighten.
3. Adjust the side straps until a comfortable fit is achieved. The
back strap can be positioned over or under the hair.
4. Adjust the headgear until the nasal pillows sits comfortably in
your nose.
5. Check that the nasal pillows are positioned upright in the
entrance of your nostrils.
Swift FX
6