Empire Comfort Systems LK9-1 Instructions D'installation page 4

18. When installing in the DVLL36BP fireplace, add (1) Small
Diffuser Screen and (1) Large Diffuser Screen over the two
outer Bulbs as shown by Figure 15. Use (1) #8 X 1/4" Screw to
secure each Diffuser screen. Check to make sure the screens
are not resting on the bulbs.
19. When installing in the DVLL48BP fireplace, add (1) Small
Diffuser Screen between the outer "V" brackets similar to as
shown by Figure 14. Use (2) #8 X 1/4" Screws to secure each
Small Diffuser screen. Check to make sure the screens are
not resting on the bulbs.
20. Figure 16 shows completed view of the LK9 Light kit in the
DVLL36BP Fireplace.
Page 4
Figure 15
Figure 16
www.empirecomfort.com
21. Figure 17 shows completed view of the LK9 Light kit in the
DVLL48BP Fireplace.
NOTE: When installing the LK9 Light Kit in the DVLL36BP, you
should have (2) "V" shaped deflectors that are not used and can
be discarded.
22. Temporarily turn on the power to the fireplace, then operate
the Remote Control to activate and test the LK9 Lights for
proper operation. Once testing is completed, turn the power
off to the fireplace prior to re-assembly.
23. Re-install the Burner Screen using the Phillips Truss Head
screws removed in step 7. Be sure to use the same screw
locations used in the screen as originally installed from the
factory. Do not overtighten.
24. Re-install the Rear Liner Panel removed in step 6.
25. Re-install the Left and Right Side panels removed in step 5.
26. Replace the Front Glass Retainer. See Figure 1.
27. To complete, follow the instructions included in the fireplace
installation manual for the proper amount and placement of
crushed glass media on the burner screen area.
NOTE: Do not apply more than one layer of crushed glass
over the burner porting areas. Install Glass Door and Barrier
Screen assemblies.
28. To operate the Accent Lights, review the instructions packed
with the fireplace remote control. The remote does not have
to be reprogrammed to operate the light kit.
29. Installation is complete.
Empire Comfort Systems Inc.
Belleville, IL
If you have a general question
about our products, please e-mail
us at info@empirecomfort.com.
If you have a service or repair
question, please contact your dealer.
Figure 17
40533-1-0220