Empire Comfort Systems LK9-1 Instructions D'installation

INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE AFTER INSTALLATION.
CARTON CONTENTS
Description
Light Bracket Assembly
Deflector, End
Deflector, Center
Diffuser Screen, Small
Diffuser Screen, Large
TOOLS NEEDED:
• 1/4" and 5/16" Hex Drivers
• Phillips Screw Driver
• Gloves
INSTALLATION
Disconnect 120V power source prior to installation of the
Accent Light Kit.
1. Using gloves, unpack contents and check for damage.
2. Refer to the fireplace installation instructions if needed to
remove the Barrier Screen assembly.
3. Remove the Glass Door assembly and set aside.
4. Remove the Front Glass Retainer by simply lifting upward
and set aside. See Figure 1.
40533-1-0220
INSTALLATION INSTRUCTIONS
LK9 - 1 ACCENT LIGHT KIT
FOR USE ON MODELS: DVLL36BP90(N,P)-1 OR
DVLL48BP90(N,P)-2 LINEAR FIREPLACES
Quantity
1
2
4
3
2
WARNING
Figure 1
Empire Comfort Systems Inc. • Belleville, IL
5. Remove the Left and Right Side Liners. See Figure 2.
Remove (1) 5/16" X 1/2" Hex screw from each side panel
located at the top rear corner of the side panel. Once the
screw is removed, carefully grasp the top edge of the panel
and work forward to release from the front retainer flange.
Insulation is glued to the back of these liner panels and must
not be removed.
6. Remove the Rear Liner Panel. See Figure 3. Remove (2)
5/16" X 1/2" Hex screws at the top of the rear panel. To remove
panel, pull the top forward slightly, then lift up to release the
panel, and set aside.
Figure 2
Figure 3
Page 1