Publicité
Les langues disponibles
Les langues disponibles
7.
Using a Phillips screwdriver, remove the Phillips Pan Head
screws that secure the Burner Screen to the Burner, and set
aside. DVLL36BP has (7) screws, and the DVLL48BP has (9)
screws. See Figure 4.
8.
To install the LK9 Light kit, first lay the Light kit assembly
out on the floor or table end to end as shown by Figure 5.
For installation in the DVLL36BP fireplace, the three light
brackets will overlap to have an overall length of 30" long
when assembled. For installation in the DVLL48BP fireplace,
the three light bracket ends overlap, and will have an overall
length of 42" long when assembled.
9.
Install the Light bracket assembly with the Right Side bracket
that includes the Green Ground wire first. Feed the ground wire
and light wires with male terminal ends through the center/right
burner support bracket and then through the right end burner
bracket. See Figure 6.
Page 2
Figure 4
Figure 5
Figure 6
Empire Comfort Systems Inc. • Belleville, IL
10. Locate and remove the 5/16" Hex Hd screw on the right side
of the Firebox as shown in Figure 7, then re-install while
securing the end of the Green Ground wire terminal. Remove
the two pink protective terminal caps from the two tan light
accessory wires located near the right side of the firebox (see
inset) and discard, then connect these tan wires to the LK9
Light wire terminals. See Figure 7.
11. Continue installing the Center Light bracket through the
center/right burner bracket until there is enough room to feed
the Left Light Bracket through the center/left burner bracket.
Shift the Left Light Bracket to the left so it rests in the left end
burner bracket. See Figure 8.
12. Align the Center Light bracket onto the two center burner
brackets, then place the Left and Right Light bracket ends on
top of the Center Light bracket ends. There are 1/8" X 1/8"
notches on the bottom edges of the Light brackets that will nest
onto the burner brackets. When installing in the DVLL36BP
fireplace, the Left and Right Light brackets will overlap the
Center Light bracket approximately 6". When installing in the
DVLL48BP fireplace, the Left and Right Light brackets will
overlap the Center Light bracket about 1". Secure the Left
and Right Light brackets to the Center Light bracket with (4)
#8 X 1/4" Screws as shown in Figure 9.
Figure 7
Figure 8
40533-1-0220
Publicité
