Empire Comfort Systems LK9-1 Instructions D'installation page 3

13. Once the three light brackets are screwed together, make sure the
Light bracket assembly is seated down on the burner brackets,
then arrange any extra wiring below the Light brackets.
Make sure wiring is not pinched under the light brackets.
14. Attach two End Deflectors (one at each end of the Light bracket
assembly) with (2) # 8 X 1/4" Screws each. See Figure 10.
15. Attach the "V" shaped Deflectors to the Light bracket assembly.
Two are required between the center burner brackets if installing
in the DVLL36BP fireplace. Four "V" shaped Deflectors are to
be installed when installing in the DVLL48BP fireplace. The
Deflectors are placed between the light sockets and secured
with (2) #8 X 1/4" Screws each. See Figure 11 for DVLL36BP
install, and Figure 12 for DVLL48BP install.
40533-1-0220
Figure 9
CAUTION
Figure 10
Figure 11
Empire Comfort Systems Inc. • Belleville, IL
16. Install the (5) Halogen light bulbs into the Light bar sockets.
When installing, take care not to touch the bulbs with your
fingers directly, but use the protective plastic bulb packaging
for protection from oils, etc. Take extra care when installing the
bulbs. Do not force the bulbs into the sockets. See Figure 13.
17. After the Bulbs are installed, attach the Diffuser Screens to the
Deflector brackets. Using (2) #8 X 1/4" Screws, attach a Small
Diffuser screen between the two center "V" brackets. Attach the
small screen to the front holes in the "V" brackets as shown in
Figure 14 so that the screen is over the center bulb. Check to
make sure the screen is not resting on the bulb.
Figure 12
Figure 13
Figure 14
Page 3