Hama TWS Sport 1T177063 Mode D'emploi page 7

Note
If pairing was successful, the status LEDs of the earphones (7) slowly flash
blue. A voice says, 'Connected'.
• You can now use the earphones.
5.2. Automatic Bluetooth
(after successful pairing)
Note
• Make sure that your Bluetooth
is activated.
• For more information, please refer to the operating instructions of your terminal
device.
• Remove the earphones from the charging box at the same time. A voice says,
'Power on – Connected'.
• After the headset and terminal device have been paired, a connection is
established automatically.
• You can now use the earphones.
Note
• If pairing was successful, the status LEDs of the earphones (7) slowly flash
blue. A voice says, 'Connected'.
• It may be necessary to change the settings on your terminal device to enable it
to automatically connect to the paired earphones.
Note - Connection impaired
After the headset and terminal device have been paired, a connection is
established automatically. If the Bluetooth
automatically, check the following:
• Go to the Bluetooth
Hama TWS Sport earphones are connected. If not, repeat the steps listed
under 5.1 Bluetooth
• Check whether obstacles are impairing the range. If so, move the devices closer
together.
• The performance can also be affected by a weak battery.
6
connection
®
-capable terminal device is on and Bluetooth
®
settings on your terminal device and check whether the
®
pairing.
®
connection is not established
®
®