Hama TWS Sport 1T177063 Mode D'emploi page 5

Warning – High volumes
• Always keep the volume at a reasonable level. Loud volumes, even over short
periods, can cause hearing loss.
• Using this product limits your perception of
ambient noise. For this reason, do not
operate any vehicles or machines while
using this product.
4. Getting Started
• The two earphones and the charging box are equipped with a rechargeable battery.
• The batteries must be fully charged before using the product for the first time.
• Ensure that the earphones are switched off before charging them.
• Begin charging by connecting the included USB charging cable to the charging
terminal (3), and to the USB connection of a PC/laptop or to a suitable USB
power supply unit.
• Place the earphones in the charging box, making sure to match them with their
correct positions (refer to the L and R labelling on the product).
• The status LEDs of the earphones (7) are constantly lit red during charging.
• After a full charge, the status LEDs (7) of the earphones go out.
• The LEDs of the charging box (2) flash white during charging. Once charging is
complete, they are constantly lit white.
• The charge level of the charging box, with the earphones inserted, is indicated by the
number of LEDs that are illuminated. Each LED represents approximately 25%.
• Disconnect all cable and mains connections after use. After the cable and mains
connections have been disconnected, the LEDs of the charging box (2) are lit
for about 30 seconds and then go out.
Note
If you have not used the item for a few month, it may take 15-30 minutes for the
status LEDs (2/7) to red when charging.
5. Operation
Switching the earphones on/off
• Turn On:
Remove the earphones from the charging cradle at the same time. Both
earphones switch on automatically. A voice says, 'Power on' and the status LEDs
(7) flash blue.
4