Volvo Penta D130 Mode D'emploi page 4

Before the tachometer is used, the correct code for the engine must be set.
I I I I I N N N N N S S S S S TR TR TR TRU U U U U C C C C C TI TI TI TI TIO O O O O N FO TR N FO N FO N FO N FOR C R C R C R CO O O O O D D D D D E S R C
Setting step
Connected to system
voltage
Press in pin B and
release pin B
(Pin B is not included in
the tachometer kit)
Press in pin B
Remove pin B when the
correct code is
displayed
*
* = I * = IM M M M M P P P P P O O O O O RT * = I RT RT ANT W ANT W
* = I * = I RTANT W RT ANT Wait for 10 seconds ANT W
with the unit connected to system volt- with the unit connected to system volt- with the unit connected to system volt-
with the unit connected to system volt- with the unit connected to system volt-
age to confirm the code setting. age to confirm the code setting. age to confirm the code setting.
age to confirm the code setting. age to confirm the code setting.
E S E SETTI E S E S ETTI ETTI ETTIN N N N N G G G G G ETTI
ait for 10 seconds ait for 10 seconds
ait for 10 seconds ait for 10 seconds
Shown on display A Descriptions
Codes are scrolled at
1 second intervals
This is your code (com-
pare with code table)
Switches to hours
counting