AEG DD 9863 Mode D'emploi page 81

Installation - Fig. 8-9
Remove the perimeter air suction panels, the inner crosspiece and the
grease filters.
• Mark a central line on the wall to facilitate the installation procedure
(1). Position the drilling template so that the median line printed on it
corresponds to the central line marked previously, and so that the
lower side of the template corresponds to the lower part of the
cooker hood once it has been fitted (2).
• Make 4 holes with Ø 8 mm (2 on top and 2 underneath) and fit 4
rawl plugs into them (3).
• Fix the motor assembly support bracket in place using 2 screws (4).
• Make two holes with Ø 8 mm near the ceiling and use them to fix
the support bracket of flue G in place (use the bracket as a
template – rest it against the wall which joins onto the ceiling). Insert
2 rawl plugs into the holes (5) (install deflector F underneath the
bracket using 4 screws if you wish to use the cooker hood as a filter
version) and fix the bracket in place using 2 screws (6).
• Fit the cooker hood (7) and adjust its position (8-9).
• Fix the cooker hood in place (10).
Note: Use 2 screws with washers and close off the holes using 2
large plug caps.
• Install the exhaust tube (11) leading from cooker hood exhaust
outlet B to the outside environment (ducted version) or deflector F
(filter version).
• Perform all necessary electrical connections (12).
81