Honeywell HWM-950 Serie Guide D'utilisation page 8

If your Humidifier is not working properly, refer to the following:
PROBLEM
• Power Switch is set
to "On" and Power
Indicator is off
• Little or no mist is
produced
• Reset Light illuminated
• Water overflows from
Reservoir
• Condensation forms
around humidifier
or windows.
NOTE: FAILURE TO KEEP THIS UNIT CLEAN FROM MINERAL DEPOSITS NORMALLY
CONTAINED IN ANY WATER SUPPLY WILL AFFECT THE EFFICIENCY OF OPERATION
OF THIS UNIT. CUSTOMER FAILURE TO FOLLOW THESE INSTRUCTIONS MAY VOID
THE WARRANTY.
POSSIBLE CAUSE
• Unit not plugged in
• No power at outlet
• No water in tank
• Unit is not level
• Mineral deposits on Heater
or Removable Water Tray
• Water Tank was washed
with detergent
• Water Tank is empty
• Unit not reset after refill
• Tank may be leaking
• Tank Cap is not tight
• Mist Intensity is set too high
for room size or pre-existing
humidity level.
TROUBLE SHOOTING
SOLUTION
• Plug unit in
• Check circuits, fuses,
test outlet.
• Fill Water Tank.
• Place on a level surface.
• Clean Heater and
Removable Water Tray
• Rinse thoroughly with
clean water.
• Refill Water Tank
• Follow Reset Procedure
• Check the Tank for leaks
and replace if necessary
• Tighten Tank Cap
• Decrease mist output to
low or open door to the
room.