Panasonic KX-UDT111 Guide De Mise En Route page 11

Location of Controls
Navigator Key
The Navigator Key includes four arrow keys and a center key. The
arrow keys are used to adjust the ringer/receiver volume or move
the cursor to select an item. The center key is used to confirm a
selection. If in standby mode, pressing the keys perform the
following functions:
A LEFT (LOG) Used to display the Incoming call log.
B UP (VOLUME) Used to adjust the ringer volume.
C RIGHT ( ) Used to open the phonebook.
D DOWN (REDIAL) Used to display the Outgoing call log.
E CENTER Used to display the Menu.
HOLD/Voice Message Key
During talking, used to place a call on Hold. In standby mode,
pressing this key plays your voice messages.
Headset Jack
The following headsets can be used with this unit. (Not all operations
with the headsets can be guaranteed.)
- Panasonic KX-TCA400 and KX-TCA430
For up-to-date information about headsets that have been tested
with this unit, refer to the following web site:
https://panasonic.net/cns/pcc/support/sipphone/
Silent Mode Key
Used to turn Silent Mode on or off when pressed for more than 2
seconds in standby mode.
Flexible Key
Pressing the key displays a menu with functions that have
FLEX
been assigned to each dial key (0–9, , and #). The functions can
be selected from the menu, or accessed quickly by pressing ,
FLEX
then the assigned key.
Receiver
Display
Soft Keys
The handset features 3 soft keys. By pressing a soft key, you can
select the feature shown directly above it on the display.
11