Zuchetti KOS Quadrat Manuel D'installation, D'emploi Et D'entretien page 42

En - USE Of THE OTHEr cOnTrOLS
USE OF THE INTERNAL KEYBOARD
Setting the temperature
Use the UP/DOWN button to increase/decrease the temperature
value displayed: keeping it pressed once, the value increases, keep-
ing it pressed twice the value decreases. If the temperature of the
water is lower than the pre-set one, the heater will be automatically
enabled until the set temperature is reached.
The "heater" LED will light up in the "fixed" mode.
Whirlpool start
Pressing this key:
once -> starts the left nozzles
Twice -> starts at the same time the left, right and front nozzles
three times -> starts the right e front nozzles
four time -> the function deactivates.
Blower start
Pressing this key:
once -> starts the blower nozzles of the minipool.
twice -> the function deactivates.
Chromotherapy start
Pressing this button, chromotherapy is enabled: a sequence of 5
different colours starts that are repeated cyclically.
Pressing the button a second time, the sequence is disabled and
the colour displayed at the time the button was pressed is held.
By pressing the button a third time, the chromotherapy function
will turn off.
CONTROL FUNCTIONS FROM INSIDE THE QUADRAT
The temperature of the water cannot be adjusted from
inside the pool but only using the keypad or remote
control.
1
2
3
1 - activation of the left nozzles (or Milk)
2 - activation of theblower
3 - switching on/off of the chrometherapy
function
4 - activation ofright and front nozzles
4
42
Quadrat