Sealey SPI1S Mode D'emploi page 11

notE: this charger is equipped with an auto-start feature. current is
supplied to the battery clamps before a battery is connected, and the
clamps may spark if touched together.
BAttErY inforMAtion
this charger can be used with 3-celled (6V) and 6-celled (12V) lead-acid
batteries with rated capacities of 12Ah (6V) and 1.2-50Ah (12V).
cHArGinG A BAttErY in tHE VEHicLE
1.
turn off all the vehicle's accessories.
2.
Keep the hood open.
3.
clean the battery terminals.
4. Place the charger on a dry, non-flammable surface, or use the
convenient hook attachment to hang the unit safely outside the work
area.
5.
Lay the Ac/Dc cables away from any fan blades, belts, pulleys and
other moving parts.
6.
connect the battery, following the precautions listed in sections 6
and 7.
7.
connect the charger to a live grounded 230V Ac outlet.
8.
the green PoWEr LED will light.
9.
When charging is complete, disconnect the charger from the Ac
power, remove the clamps from the vehicle's chassis, and then
remove the clamp from the battery terminal.
cHArGinG A BAttErY outsiDE of tHE VEHicLE
1.
Place battery in a well-ventilated area.
2.
clean the battery terminals.
3.
connect the battery, following the precautions listed in sections 6
and 7.
4.
connect the charger to a live grounded 230V Ac outlet.
5.
the green PoWEr LED will light.
6.
When charging is complete, disconnect the charger from the Ac
power, disconnect the negative clamp, and finally the positive clamp.
7.
A marine (boat) battery must be removed and charged on shore.
usinG tHE QuicK-connEct cABLE connEctors
connect either of the two (2) output cable leads to the charger. Make sure to
place the charger on a dry, non-flammable surface.
never connect the clip and ring terminal connectors
IMPORTANT
together for use in other applications, such as external
battery or other power source charging, or to extend the output cable
• 11 •