Warning Messages Via The Display; Appliance Self-Test - Thermador T36BT Série Guide D'utilisation

Warning
messages
via the display
If several warning messages are
displayed simultaneously, deal with
each message individually.
While a warning message is
displayed, buttons cannot be
pressed.
Temperature alarm
(Freezer compartment)
A temperature alarm is indicated by
the required temperature flashing
and the ALARM symbol coming on.
A signal also sounds if the Tone
function has been activated in Setup
mode.
Cause
– Power failure
– Large quantities of fresh produce
placed in the appliance
– Fault with the appliance
Remedial action
Press the ALARM OFF button.
The signal stops. The highest
temperature in the appliance is
displayed for several seconds.
Determine the cause of the
temperature alarm.
When the required temperature
is reached again, the ALARM
symbol goes out and the signal
stops.
20
Door alarm
Cause
– An appliance door has not been
closed properly or has been open
too long.
Remedial action
Close the door.
The display goes out.
Sensor fault
Cause
– A technical defect is possible.
Remedial action
Conduct an appliance self-test.
Low voltage
The display light has gone out.
Cause
– The mains voltage has dropped
below the permitted limit value.
Remedial action
Buttons cannot be pressed.
When the mains voltage reaches
the stipulated value again,
the warning message goes out.
If the warning message is prolonged,
inform your power supply company.
Appliance
self-test
Before you call customer service,
conduct an appliance self-test.
Switch off the appliance and
wait 5 minutes. Keep the door
closed.
Switch on the appliance.
Simultaneously hold down
the SETUP and ALARM OFF
buttons for 5 seconds.
The self-test starts. Different
messages are display in succession.
If a fault is detected during the
self-test, the ALARM symbol and
a corresponding error message,
e.g. for a sensor fault, are displayed.
Inform customer service about
the error message.
If the appliance self-test does not
establish any faults, the required
temperature is displayed on
completion of the self-test.