Connections To Output Components (Bi-Amp Connections) - TAD -C2000 Manuel Du Propriétaire

Connections to output components (Bi-AMP connections)

Bi-AMP connections utilize two amplifiers and two sets of speaker cables, one connected to the speakers' low-range input
connectors (Low) and the other connected to the speakers' high-range input connectors (High).
Note
When using balanced (XLR-3-32) connections, use output connectors 1 or 2.
'
When using unbalanced (RCA pin-jack) connections, use output connectors 3 or 4.
'
When using multiple power amplifiers, use either power amplifiers with four inputs, 2 identical stereo power amplifiers, or
'
4 identical monaural power amplifiers.
Use the same power amplifier for L and R channels.
'
Proper balance values for high and low ranges will not be obtained if the amplifiers used for high and low ranges have
'
different gain characteristics.
Rear of speaker
when using bi-amp
connections
-
Speaker
CAUTION
Do not turn on power to this unit and other components until all connections and switch settings have been completed.
'
The same sound volume will be output from the analog output connectors 1, 2, 3, and 4 for the same channel (L or R).
'
In order to prevent negative effects on the amplifier from the speakers when using Bi-AMP connections, the speakers'
'
accessory High-Low short bar must be removed. For details, consult the operating instructions for your speakers.
Do not connect anything other than dedicated XLR cables to the XLR input/output connector.
'
14
（TAD-M2500）
12V
INPUT R INPUT L
TRIGGER
BALANCED UNBALANCED UNBALANCED BALANCED
IN
SPEAKER R SPEAKER L
ON AUTO
POWER
OFF DOWN
BALANCED
UNBALANCED
+ - - +
AC IN
+
High
Low
R
ANALOG INPUT ANALOG OUTPUT
BALANCED
1. GROUND 2. HOT(+) 3. COLD(-)
LINE 1 BALANCED LINE 2 BALANCED
LINE 3 LINE 4
DIGITAL INPUT
D3
D1
USB
D2
XLR COAXIAL
（TAD-M2500）
12V
INPUT R INPUT L
TRIGGER
BALANCED UNBALANCED UNBALANCED BALANCED
IN
SPEAKER R SPEAKER L
ON AUTO
POWER
OFF DOWN
BALANCED
UNBALANCED
+ - - +
AC IN
L
ANALOG INPUT ANALOG OUTPUT
BALANCED
1. GROUND 2. HOT(+) 3. COLD(-)
LINE 1 BALANCED LINE 2 BALANCED
LINE 3 LINE 4
12 V TRIGGER
1 2 3
4 5
AC IN
IN OUT
OUTPUT 12 V
TOTAL 125 mA MAX
Rear of speaker
when using bi-amp
connections
- +
High
Low
Speaker