Rear Panel - TAD -C2000 Manuel Du Propriétaire

Rear panel

12
ANALOG INPUT
LINE 1 BALANCED LINE 2
DIGITAL INPUT
D3
USB
16
12 ANALOG INPUT R connectors
Select either balanced (XLR-3-31) or unbalanced (RCA pin jack)
connectors in accordance with the type of connectors on the
component to be connected.
13 ANALOG OUTPUT R connectors
Select either balanced (XLR-3-32) or unbalanced (RCA pin jack)
connectors in accordance with the type of connectors on the
power amplifier to be connected.
14 ANALOG INPUT L connectors
Select either balanced (XLR-3-31) or unbalanced (RCA pin jack)
connectors in accordance with the type of connectors on the
component to be connected.
15 ANALOG OUTPUT L connectors
Select either balanced (XLR-3-32) or unbalanced (RCA pin jack)
connectors in accordance with the type of connectors on the
power amplifier to be connected.
16 DIGITAL INPUT connectors
Select either USB, COAXIAL, or XLR in accordance with the
type of connectors on the component to be connected.
10
13
R
ANALOG OUTPUT
BALANCED
1. GROUND 2. HOT(+) 3. COLD(-)
BALANCED
LINE 3 LINE 4
D1
D2
XLR COAXIAL
14
L
ANALOG INPUT ANALOG OUTPUT
BALANCED
1. GROUND 2. HOT(+) 3. COLD(-)
LINE 1 BALANCED LINE 2 BALANCED
LINE 3 LINE 4
12 V TRIGGER
1 2 3
4 5
IN OUT
OUTPUT 12 V
TOTAL 125 mA MAX
17 18
17 12 V TRIGGER IN connector
When an external component with a 12 V TRIGGER connector is
connected, this unit's ON/Standby power state can be changed
by operation of the power control on the external component.
Connector: Ø 3.5 mm monaural mini-jack
Operating conditions:
During power Standby mode, when input signal's voltage
changes from L to H ................................. Power switches to ON.
During power ON mode, when input signal's voltage changes
from H to L ........................................ Power switches to Standby.
When an H signal is being input to the 12 V TRIGGER IN
connector, the unit's power switch cannot be used to change to
Standby mode.
18 12 V TRIGGER OUT connectors
When an external component with a 12 V TRIGGER connector
is connected, operating this unit's power switch will change
the external component's power state (ON/Standby).
Connector: Ø 3.5 mm monaural mini-jack
Operating conditions:
When this unit is in power ON mode, an H signal is output.
When this unit is in power Standby mode, a L signal is output.
When linked to other components with 12 V TRIGGER input
connectors, a total of five connectors and maximum 125 mA
can be output. Output exceeding 125 mA is not possible, so
take care to avoid excessive current.
19 AC IN connector
Connect the accessory power cord here.
15
AC IN
19