Lcd Display - Seaward PV100 Notice D'utilisation

Solar Installation PV100
4.

2 LCD display

Figure 3 LCD display icons
a. Rpe voltage polarity. For AC voltages alternating + and – is shown.
b. Current clamp measurement active.
c. Rpe Null offset - indicates that test lead resistance offset is active.
d. Caution – hot surface. If this icon appears, the PV100 must be disconnected
immediately from the PV system until the icon is no longer shown on the LCD.
e. Solar Panel polarity indicator – indicates the polarity of the DC voltage applied to the PV
test terminals e.g. correct or reversed
f. Caution – hazardous voltage detected.
g. Rpe test lock – active when continuous Rpe measurement has been enabled.
h. Caution – refer to operating instruction. When this icon is active, the operating
instructions must be followed to avoid risk of danger.
i. Riso PASS/FAIL – indicates whether the measured insulation resistance is above or
below the factory set acceptable value.
j. Insulation Test Voltage selection – indicates the test voltage selected for insulation
resistance measurements.
k. Error – Refer to the specific error codes for further details.
l. STORE – LCD data is being stored in the onboard memory
m. RECALL – the data shown on the LCD has been recalled from the onboard memory.
n. User Memory display – indicates the memory location of the results recalled on the LCD
in relation to the total number of records in memory e.g. 2:6 indicates the second in the
total of 8 records.
o. Voltage/current variation – indicates in the measured voltage and current values deviate
by more than or less than 5%.
p. Battery status icon.
- 8 -
Operating Instructions