Maintenance; Preparing To Work On The Solar Pv100; Securing The Solar Pv100; Cleaning The Solar Pv100 - Seaward PV100 Notice D'utilisation

Solar Installation PV100

8 Maintenance

Before removing the PV100 battery cover ensure that all test leads have
been disconnected from the instrument. Electric shock danger!
Do not operate the PV100 without the battery cover securely in place.

8.1 Preparing to work on the Solar PV100.

Make sure the Solar PV100 is voltage free as follows, before opening the instrument;
Power the unit off.
Disconnect all of the test leads from the unit

8.2 Securing the Solar PV100

Under certain conditions safe operation of the Solar PV100 can no longer be assumed:
Visible damage of the instrument case.
Incorrect measurement results.
Recognisable abuse to the instrument due to prolonged storage under improper
conditions.
Recognisable abuse to the instrument due to extraordinary transportation stress.
Check the battery compartment for signs of battery electrolyte leakage.
In these cases, the PV100 should be immediately switched off, disconnected from any
test or measurement function and secured to prevent any further use.

8.3 Cleaning the Solar PV100

Clean the external case of the Solar PV100 with a clean dry cloth.
Avoid using solvents and abrasive scouring agents to clean the external case of the
Solar PV100.
Check the battery contacts and compartment are free of electrolytic contamination.
Any contamination of the battery contacts or compartment should be cleaned with a
dry cloth.
- 17 -
Operating Instructions