④ Emptying And Cleaning The Drain Tank - Mitsubishi Electric JT-MC106G-W-NA Manuel D'instruction

Maintenance - Continuation
Emptying and cleaning the drain tank
4
⚫ Empty the water in the drain tank at least once a week before the drain water exceeds the full line.
⚫ If the drain water is left inside, it can cause foul odors or the water can spill onto the fl oor and tarnish it.
Front cover
Open
Drain tank
Lid
Drain tank
Overfl ow hole
Click
Before it fi lls up (at least once a week)
Sensor
light
Sensor
switch
Full line
Drain tank
Lid
Main unit
Drain tank
1
Pull the tab, open the front cover and turn the
sensor switch "OFF".
⚫ The sensor light "OFF" is lit.
⚫ Refer to "How to open/close the front cover" on page 4.
2
Remove the drain tank while keeping it
upright.
⚫ Keep it upright when carrying it so that the drain water
does not spill.
Caution
⚫ If it is used after the full line has been exceeded, please
be careful of water spilling out of the overflow hole.
(The full line is reached at 0.6L.)
3
Open the lid and empty out the drain water.
4
Wash the drain tank and lid, and wipe them
thoroughly.
5
Put the lid back on the drain tank and reattach
it to the main unit.
⚫ Press the lid of the drain tank down using the tabs until
they make clicking sounds, and make sure that it is fitted
properly.
⚫ Push the drain tank all the way into to the main unit and
make sure that it is fitted properly.
6
Turn the sensor switch "ON" and close the
front cover so that there is no gap and push
the tab.
⚫ The sensor light "ON" is lit.
Caution
⚫ Water may enter the unit and cause short
circuits, electric shocks or damage if the front
cover is left open.
− NA - 10 −