Display Time - Belkin OmniView PRO Guide De L'utilisateur

P73055/F1D108-OSD/EU/man.qxd
SCAN TIME:
Amount of time the OmniView
on one port before switching to the next
port when in Scan Mode.

DISPLAY TIME:

Amount of time the OSD Menu or Port
Name remains displayed on-screen after
making a port selection.
NOTE: If there are slave units present, the SCAN TIME and DISPLAY TIME settings are set on
the MASTER unit only, and need not be set on the slave units.
The BANK/SCAN Button:
Pressing the BANK/SCAN button cycles you through all the active BANKS (if there are slave
units present) and then puts the unit in AutoScan mode. If the unit is a single MASTER unit,
pressing the button immediately invokes AutoScan mode. This is evident by a long BEEP,
followed by two short beeps.
4/21/00 2:25 PM Page 14
Usage
(continued)
SCAN TIME:
PRO stays
™
7sec
DISPLAY TIME:
7sec
[ ]: SELECT
(INS):
(Enter): COMPLETE
(Esc):
14
15sec 30sec
15sec 30sec
RENAME
Exit
60sec
60sec